Roofing Code: Section 1507Roofing1507.2 Asphalt Shingles. The installation of asphalt shingles shall comply with the provisions of this section.1507.2.1 Deck Requirements. Asphalt shingles shall be fastened to solidly sheathed decks.,1507.2.2
RoofingCode: Chapter 15Roofs and Roof Structures 1507.2.3, Underlayment: Unless otherwise noted, required underlayment shall conform to ASTM D 226, Type I, ASTM D 4869, Type I, or ASTM D 6757.1507.2.4,
Roofing Code:Section 1507Roofing1507.2.9.4, Crickets and Saddles:A cricket or saddle shall be installed on the ridge side of any chimney or penetration greater than 30 inches (762 mm) wide as measured
Roofing Code: Chapter 15Roofs and Roof Structures Section 1504.1, Wind Resistance of RoofsRoof decks and roof coverings shall be designed for wind loads in accordance with Chapter 16 and Sections
Roofing Code: Chapter 15Roofs and Roof StructuresSection 1507.2, Steep-Slope Roof Coverings:Steep-slope roof covering materials and installations shall comply with Section 1507.2.1 through 1507.2.9. In areas where the average daily temperature
RoofingCode: Chapter 15Roofs and Roof StructuresSection 1503.0, Construction Documents:For all roofs and roof coverings required by this code, the construction documents shall illustrate, describe and clearly delineate the type of
Section 1813.3 Dampproofing required:Where the ground water table is lowered and maintained at an elevation not less than 6 inches (152 mm) below the bottom of the lowest floor, the
Section 1505.3.1 Physical PropertiesRoof coverings shall demonstrate physical integrity over the working life of the roof based upon 2,000 hours of exposure to accelerated weathering tests conducted in accordance with
Section 1813.2.1, Ground water control Where the ground water table is lowered and maintained at an elevation not less than 6 inches (152 mm) below the bottom of the lowest
RSS